Download Note: Depending on the year, make, and model of your vehicle, some deviations and modifications may be needed during installation: Routing of the cable (keep it kink free) Placement of the shifter Heat Shields and grommets for cable protection. Make certain cable action is free & smooth. Use High StrengthLoctitewhere specified and allow for proper cure times. Install the 4 springs in the 4 chamfered holes. 8 -bolts, º-28 thread 8 -spring washers 1 -small carrier cap 1 -thrust washer 1 -locking ring gear 1 -locking side gear 4 -springs 1 -big carrier cap (attached to carrier) Install thrust washer behind locking side gear. Carrier Assembly 1. 2. OX Locker needs final assembly. Remove all packaging including any tie wraps. Picture shows the parts that need to be assembled:1 -long shaft 1-spider gear 1 -snap ring 1 -dowel pin 1 -spider gear cap 1 -set screw 1 -spider gear washer. Remove the small cap, locking ring, locking gear and the following parts shown-set screw, dowel pin, shaft, spider gear (on opened end) spider gear washer, spider gear cap and snap ring 4. Your carrier should now look like this-open on one side with the shaft and spider gear missing. This will enable you to install your axles and c-clip later through these procedures. Install locking side gear with gears facing engagement with spider gears Slide the ring gear around the carrier. 5. 6. Install locking ring gear with gears facing engagement with locking side gear The flat side must be facing up! Push locking ring down and let the springs return it to ensure smooth operation (repeat several times). 7. 8. 3. Remove the small cap, locking ring, locking gear and the following parts shown-set screw, dowel pin, shaft, spider gear (on opened end) spider gear washer, spider gear cap and snap ring 4. Your carrier should now look like this-open on one side with the shaft and spider gear missing. This will enable you to install your axles and c-clip later through these procedures Install small carrier cap -align holes, make sure it slides into locking side gear smoothly. NOTE: Make sure this cap sits flush with all 8 cams -if cap is not flush, it could cause severe damage to the carrier Install the º bolts and spring washers. IMPORTANT!!! Apply high strengthloctite (red) to bolts.
↧